· Brilliance BMW recalled recalling some domestic and imported 2 Series, 3 Series and M3 vehicles

Recently, BMW (China) Automobile Trading Co., Ltd. and BMW Brilliance Automobile Co., Ltd. filed a recall plan with the AQSIQ according to the requirements of the Regulations on the Management of Defective Automobile Product Recall, and decided to start 2015 from July 10, 2015. The range of vehicles for some domestic and imported 3 Series, 4 Series and M3 vehicle recalls, which was implemented on January 12, was expanded, and the following vehicles were recalled, totaling 3,201:
(1) Some BMW 218i (tour wagon), 220i (tour wagon), 320i (GT), 335i (GT) produced by BMW (China) Automobile Trading Co., Ltd. from September 22, 2014 to January 21, 2015. ), M3 cars, a total of 1,643 vehicles;
(II) Some BMW 316i, 316Li, 320i, 320Li, 328i, 328Li, 328Li xDrive vehicles produced by BMW Brilliance Automotive Co., Ltd. from November 20, 2014 to January 27, 2015, totaling 1,558 vehicles.
The reason for the expansion of this recall is that there are manufacturing defects in the right seat belt on the front side of some vehicles. When the temperature is below 0 degrees Celsius, the front seat belt on the front side may be difficult to pull out or even pull out, resulting in the front passengers being unable to fasten the seat belts, and the passengers losing seat belt protection, posing a safety hazard. BMW (China) Automobile Trading Co., Ltd. and BMW Brilliance Automotive Co., Ltd. will inspect the vehicles within the scope of the recall and replace the front right seat belts for the vehicles in question to eliminate safety hazards.
BMW (China) Automobile Trading Co., Ltd. and BMW Brilliance Automotive Co., Ltd. will contact the relevant owners through authorized dealers to arrange maintenance. Users can call the BMW Customer Service Hotline at 400-800-6666 for consultation. The owner can also visit the website of the AQSIQ (), the website of the AQSIQ Defective Product Management Center (), and the China Auto Recall Network (). ) and pay attention to the WeChat public account (AQSIQDPAC) for more information. In addition, you can also call the AQSIQ Defective Product Management Center hotline, 010-65537365 to reflect the problems in the implementation of the recall or submit defects.

Hydraulic Support System Seals Kits

Hydraulic Support System Seals Kits

Hydraulic sealing equipment widely used in mine engineering and support system in tunnels
Mining hydraulic support sealing kit
Design description
The piston combined seal consists of a sealing ring, an elastomer and two retaining rings.
The sealing ring plays a sealing role, and the material is high-performance water-resistant polyurethane;
Elastomer provides elastic preload and wear compensation, and the material is NBR;
The retaining ring plays a protective role against extrusion,
The material is polyformaldehyde (POM).
Operating conditions
Maximum pressure: 70MPa,
Maximum speed: 0.3m/s
Temperature range: - 35 ° C~+110C
Working medium: 5% emulsion (HFA)

Hydraulic Construction Machinerhy,Zuigerafdichtingen,Hydraulic Pump Parts,Hydraulic Support,Hydraulic Support System

Safe Seal Technology Co., Ltd. , https://www.sprsealkits.com