Three-roll gate swing gate wing gate installation instructions
Three-roll gates, swing gates, wing gates, turnstiles, etc. Pedestrian walkway gate installation steps Description (1) Line embedded According to the customer's requirements, the position of the chassis will be set well. For example, the concrete base can be poured and can be completed in advance (the size of the base must be The size of the bottom of the gate is about 100-150mm larger than the size of the gate, and the cable trench is embedded or excavated between the control box or the booth at the center of the fixed position of the barrier, and the line pipe is buried. Square millimeters of power cord and 4x0.5 square millimeters of control wire, after correcting, backfill the concrete. 
(2) Fix the chassis Put the chassis in a fixed position, open the door of the chassis, and loosen the wing nut fixing the hat (put the door and cap of the chassis carefully, avoiding scratches on the surface). Then, mark the center of the screw hole of the chassis bottom and the edge of the chassis base, remove the gate, and use the drill to make a vertical hole on the screw hole (the size of the drill bit must match the expansion bolt of the equipment). The depth must meet the length of the expansion screw. Move the chassis to its original position, insert the expansion screw, and fasten firmly.
(3) Mounting of the gate rod After the channel gate chassis is fixedly secured, the gate rod can be installed at the handlebar position and tightened with the provided screws, and it is determined that the gate rod is not inclined. If you need to install the fork rod, after adjusting the vertical and horizontal state, manually swing the brake rod to the horizontal position, determine the installation position of the fork rod at the end of the rod, and fix the fork rod firmly with the screw (there is no need to install without the fork rod ).
------- Entrance channel gate manufacturer Shenzhen Qianhang Intelligent Technology Co., Ltd.
Flat packaging bags are a great choice for food packaging, powdered mixes, small products, and flat paper items. These bags could also been in sheet or in roll. With good grade material, nice heat sealing, the bags are water-proof and good for storage.
The packaging bags in roll
Food packaging in sheet
Flat Barrier Bags,Flat Bag On Roll,Flat Bag On Sheet,Side Sealing Flat Bag,Poly Bag Roll,Food For Go Bag
BILLION PLASTIC MANUFACTURING CO.,LTD, JIANGMEN , https://www.jmplasticbag.com